S : Airbag Indicator Light; T: Lights And Switches; U: Installation Of Steering Components; V: Exhaust Pipe And Muffler - Subaru SVX 1992 Manual

PRE-DELIVERY INSPECTION lolvol 1-4
3) Discard jumper connector after removal.
FS
: AIRBAG INDICATOR LIGHT
CHECK POINTS
Operation of AIRBAG indicator light
When the ignition switch is turned to the "ON" posi-
tion, the Supplemental Restraint System (AIRBAG)
indicator light will come on for about 8 seconds, to
show normal system operation, and then turn off.
FT
: LIGHTS AND SWITCHES
CHECK POINTS
1 . Visual inspection of lights (installation, damage,
dirty lenses, water inside, etc.)
2. Operation of all lights and switches
3. Horn operation
4. Operation of heater and ventilator
5. Removing the clip for room light switch
U : INSTALLATION OF STEERING COMPO-
NENTS
CHECK POINTS
1. Installation of universal joints
2. Steering gear box for looseness, play, or back-
lash, and boots for damage
3. Tie-rod and tie-rod end for proper installation, or
damage
1 . Check the universal joint for looseness.
When checking, turn ignition switch to "ACC" posi-
tion.
Tightening torque :
21 - 26 Nam (2.1 - 2 .7 kg-m, 15 - 20 ft-Ib)
2 . Check the gear box mounting bolt for looseness .
Tightening torque :
47 - 71 Nam (4 .8 - 7.2 kg-m, 35 - 52 ft-Ib)
3. Check the tie-rod end lock nut for looseness .
Tightening torque :
78 - 88 Nam (8.0 - 9 .0 kg-m, 58 - 65 ft-Ib)
Fig . 21
4. Carefully check the root portion of the boots, and the
condition of the clips.
Fig. 22
V: EXHAUST PIPE AND MUFFLER
CHECK POINTS
1 . Exhaust system's installation
2. Exhaust gas leakage
1 . Check the exhaust system's installation for loose-
ness, damage and possible interference with other
parts . (Refer to Chapter 2-9 for tightening torque.)
When the engine is running, and for a short time after
it is stopped, the exhaust system remains very hot ; use
extreme care and don't get burnt during this evolution .
Fig. 20
9