Subaru SVX 1992 Manual page 521

AUTOMATIC TRANSMISSION AND DIFFERENTIAL [W4B6) 3- 2
Tightening torque :
3.4 - 4 .4 Nom (0 .35 - 0.45 kg-m, 2.5 - 3.3 ft-Ib)
Tighten the bolts evenly .
Insert it fully into position until the bearing shoulder
bottoms .
4) Measurement and adjustment of extension end play
(1) Measure distance L from end of extension case
and rear drive shaft .
Fig. 217
5. EXTENSION SECTION
When installing new oil seal into extension case, press
it with INSTALLER (498057300) .
1) Install the filter in the extension case .
Pay attention to the orientation of the filter.
2) Install the transfer clutch valve ASSY, and secure
with four bolts.
Tightening torque :
7 - 9 N "m (0.7 - 0.9 kg-m, 5.1 - 6.5 ft-Ib)
a. Be sure to tighten the going lead with one of these
bolts.
b. Be sure to use a new gasket.
3) Install the pipe, and clamp securely .
4) Install the transfer clutch assembly to the case .
a. Be careful not to damage the seal rings.
b. Insert the clutch assembly fully into position until
the bearing shoulder bottoms .
6. CONNECTION OF EACH SECTION
1) Install the reduction driven gear .
2) Install the parking pawl and shaft, set the selector
lever in the "P" range and tighten the drive pinion lock
nut.
Tightening torque :
93 - 103 N"m (9 .5 - 10 .5 kg-m, 69 - 76 ft-Ib)
After tightening, stake the lock nut securely.
3) Install the reduction drive gear ASSY .
Fig. 218
L = Measured value - 15
(2) Measure the distance "C" from the transmission
case mating surface to the reduction drive gear end
surface.
GAUGE
15 + 35 mm
(398643600)
(0 .59 + 1,38 in)
~l
GAUGE
_ (499577000)
t
u ;n V J
o
r
B3-353
Fig . 219
C = Measured value - 50
(3) Calculation equation :
Unit : mm
T= (L+ 0.4)-e
T : Clearance between end of reduction drive gear
and end of rear drive shaft .
147