Table of Contents
Advertisement
2-3 [M8001
ENGINE
8 . Cylinder Block
The cylinder block is made from aluminum diecast . The
cylinder perimeter has an open-deck design which is
lightweight, highly rigid and has superb cooling effi-
ciency .
The cylinder liners are made from cast iron and are dry
types which are totally cast with aluminum cylinder
block. Seven main journal block designs are employed
to increase stiffness and quiet operation . The oil pump
is located in the front center of the cylinder block and
the water pump is located at the front of the left-cylinder
bank. At the rear of the right-cylinder block is a separa-
tor which eliminates oil mist contained in the blow-by
gas .
Oil separator cover
I
t
a
i~
~1~~
" ' m s s
o
-
` \
~/
o
10
Cylinder block (RH)
`®v --o
,
a0
'+V
Uo
Cylinder block (LH)
C2-190
Fig . 7
8
Advertisement
Table of Contents
Troubleshooting
