Subaru SVX 1992 Manual page 1002

AUTOMATIC AIR CONDITIONING SYSTEM [w15C0I 4-7
13) Letdown vehicle .
14) Move radiator toward engine, and remove con-
denser from gap between radiator and radiator panel .
B: INSTALLATION
1) To install, reverse removal procedures .
a. Make sure guide pin on upper condenser bracket is
securely inserted into hole in radiator panel.
b . Replace old O-ring (used with piping) with new one,
and apply a coat of compressor oil to it before install-
ing.
C: INSPECTION
1) Make sure the condenser fins are free from dust and
insects . If the fins are clogged, clean by blowing air or
water through them .
To prevent dust and water from getting into the
condenser, this work must be done when the con-
denser is installed in an actual vehicle .
2) Check the condenser to see if it shows any sign of oil
seepage . Should oil ooze or gas leak from the con-
denser replace it with a new one .
torque: N-m (kg-m, ft-Ib)
T1 : 10 - 20(1 .0-2 .0,7-14)
T2 : 5.4 - 9.3(0 .55-0.95,4.0-6.9)
C4-648
Fig. 158
67