Subaru SVX 1992 Manual page 822

STEERING SYSTEM
[T4C3] 4-3
1 . CHECK SOLENOID UNIT
1) Turn ignition switch "OFF ."
2) Disconnect connector (1317) .
3) Measure resistance solenoid connector terminals
(indicated below) using digital ohmmeter .
Connector fr Terminal/Specified resistance :
(1317) No. 1 - No. 2/5 - 9 C1
on I valve C tro
solenoid
C4-575
Fig . 189
2. CHECK HARNESS BETWEEN ECU AND SOLE-
NOID
1) Disconnect ECU from connector .
2) Connect connector (1317) .
3) Check resistance and continuity between connector-
(B53) terminals indicated below.
3 . CHECK HARNESS
1) Turn ignition switch "OFF."
2) Disconnect ECU from connector (1317) .
3) Measure voltage across connector-(1317) and GND.
Connector Fr Terminal/Specified voltage:
(1317) No. 2 - Body/0 V
(For reference)
When battery voltage is produced, line between power
supply harness and solenoid @ terminal is shorted to
set solenoid in "full assist" state .
a
V
1317
1 z
Body side
-
connector
04-577
Fig. 191
Connector fr Terminal/Specified resistance :
(1353) No. 9 - 11/5 - 9 f2
(1353) No . 9 - Body/1 MSS min.
R
1353
L81 7
6 5 4
3 2 1
1 16 1 15 1 14 1 13 12 11 10 9
Return Slde
Q+ side
C4-576
Fig. 190
93