P: Fuses; Q: Diagnosis Connector - Subaru SVX 1992 Manual

1-4 101POI PRE-DELIVERY INSPECTION
3) Install the anchor at the installation point .
Tighten the bolt so that the anchor is completely se-
cured .
4) Attach the cover to the anchor plate .
5) Route top strap under pillow .
6) Attach the hook of the top strap to the anchor.
Fig. 16
a. Be sure to install the plate anchor set in the correct
direction.
b. Before tightening the plate anchor set, position the
plate in the pawl of the cover. Do not allow the cover
base to be caught between the plate anchor and
spacer.
c. Always use a genuine top strap anchor.
d. Be careful not to scratch seat cover when installing
top strap hook.
P : FUSES
CHECK POINTS
1 . Fuse installation
2. Spare fuse
Fuse as shown in Figure 17 is disconnected to avoid
discharging the battery .
Insert fuse (10A) in the main fuse box inside the engine
compartment.
Use fuse indicated by arrow in Figure 17 .
Q: DIAGNOSIS CONNECTOR
CHECK POINTS
1 . Check engine light flashing .
2. Jumper connector removal.
Check the check engine light flashing.
a. With the jumper connector connected, set the igni-
tion switch to ON (with engine OFF and ON) . Flashing
of the check engine light indicates no trouble.
b . If the check engine light displays a trouble code
when the ignition switch is set to ON (with engine
OFF), or if the check engine light illuminates with
engine ON, this indicates that a trouble has occurred.
Check Troubleshooting . Refer to 2-7 : FUEL INJECTION
SYSTEM.
c. If engine fails to turn over when the ignition switch
is set to START, check the spark plugs. Refer to 6-1 :
Spark Plug [W4A0] .
Check the jumper connector removal .
a. Disconnect the jumper connector after checking
that there is no trouble in the engine .
1) Remove the A pillar lower trim of driver side front
pillar .
=II
pillar
\~ulloll II il_I
- A wer trim
rt~l /h,
Iv - .
L Diagnosis connector
~>>ll
C1 -028
Fig . 18
2) Disconnect the jumper connector from diagnosis
connector.
Fig . 17
I
_ 1 \~,\'
l , f
Diagnoses
connector I
Oat]
o
Jumper connector
Cl-029
Fig . 19
8