Pre-Road Test Inspection; Pre-Delivery Inspection; B: Door Operation And Door Lock; C: Trunk Lid And Fuel Lid Operation - Subaru SVX 1992 Manual

1-4 101A01
PRE-DELIVERY INSPECTION
1 . Pre-road Test Inspection
L
A: HOOD OPERATION
CHECK POINTS
1 . Operation of hood release and lock
2. Condition of lock
3. Fitting hood
B : DOOR OPERATION AND DOOR LOCK
CHECK POINTS
1 . Door "Open-close" operation
2. Operation of door release and lock
3. Loose or damage parts
4 . Position of door window glass
5. Operation of power window switches
6. Auto-door locking operation
C: TRUNK LID AND FUEL LID OPERATION
CHECK POINTS
1 . Trunk lid and fuel lid "open-close" operation
2. Operation of trunk lid (release and lock)
3. Fitting of trunk lid and fuel lid
4. Operation of trunk lid opener release lever
D: BRAKE FLUID LEVEL AND BRAKE PIP-
ING INSTALLATION
CHECK POINTS
1. Fluid level in brake reserve tank
2. Wiring of fluid leveller and its operation
3. Brake booster, master cylinder and pressure con-
trol valve for proper installation ; brake pipe,
brake hose and connectors for proper fitting
4. Leakage in any of the above
Check fluid leveller operation while pushing it down
with a screwdriver .
Fig. 1
Recommended brake fluid
FMVSS No. 116, fresh DOTS or DOT4 brake fluid
a. The fluid level must be kept at "MAX" level.
b . Do not mix different brands of brake fluid .
c. When adding brake fluid, be careful not to allow any
dirt, water, or oil around the fluid tank to enter it.
d. Never use engine oil, gear oil, or any mineral oil.
e. Use extreme care not to allow any water to get into
the fluid; water in the brake fluid will lower the fluid's
boiling point and cause vapor-lock.,
f. Use special care not to spill any brake fluid on the
vehicle's painted surfaces, because it will quickly erode
them . In case of an accident, wipe it off as quickly and
as cleanly as possible .
g. If the too much brake fluid is missing, check the
brake line for possible leakage.
h. After adding brake fluid, any excess must be stored
in a tightly sealed container.
i. When checking the operation of leveller, use clean
screwdriver or the like and be careful not to allow dirt
or dust to get into the tank.
2