Subaru SVX 1992 Manual page 214

ENGINE
[W5E2] 2-3
(2) Apply fluid packing to matching surface of oil
pump .
t-1g . 7 4d
4) Apply fluid packing to matching surfaces and install
oil separator cover.
Fluid packing :
Three-bond 1215B or equivalent
U o
Fluid packing
0
U
o O
0
B2-037
Fig . 149
5) Install drive plate.
6) Installation of oil pump .
(1) Discard front oil seal after removal . Replace with
a new one .
Ng . 15U
Fluid packing :
Three-bond 1215B or equivalent
0
0
0
Fluid packing
O
Ito
p O
\ ~~ I
o4 Oo
oh
C2-321
Fig . 151
(3) Install oil pump on cylinder block . Be careful not
to damage oil seal during installation .
(Referto2-4 ENGINE LUBRICATION SYSTEM [W1E0] .)
a. Do not forget to install O-ring and seal when install-
ing oil pump.
b. Align flat surface of oil pump's inner rotor with
crankshaft before installation .
7) Install water pump and gasket .
After tightening all bolts to the specified torque, tighten
all bolts to specified torque again .
(Refer to 2-5 ENGINE COOLING SYSTEM CW2C0] .)
Be sure to use a new gasket .
8) Install water pipe .
9) Install water by-pass pipe .
10) Install oil filter with OIL FILTER WRENCH.
2. RELATED PARTS
1) Install cylinder head and intake manifold .
(Refer to Cylinder Head [W4A0] .)
2) Install camshaft and related parts .
(Refer to Camshaft [W3A0].)
3) Install camshaft sprocket, timing belt and related
parts.
(Refer to Timing Belt [W2A0] .)
75