Subaru SVX 1992 Manual page 717

WHEELS AND AXLES [W4Do) 4-2
HOUSING STAND "REAR"
(28099 PA060)
C4-338
Fig. 94
4) Install snap ring.
Ensure snap ring fits in groove properly .
C4-336
Fig . 95
5) Using HOUSING STAND "REAR" (28099PA060) and
OIL SEAL INSTALLER "REAR" (28099PA070), press
outer oil seal until it comes in contact with snap ring .
C4-339
Fig . 96
6) Invert both HOUSING STAND "REAR" (28099PA060)
and housing .
7) Invert both OIL SEAL INSTALLER "REAR"
(28099PA070), using it press inner oil seal into housing
until it touches bottom.
OIL SEAL INSTALLER "REAR"
170)
HOUSING STAND "REAR"
(28099 PA060)
C4-340
Fig . 97
8) Apply sufficient grease to oil seal lip .
Specified grease:
SHELL 6459N
a. If specified grease is not available, remove bearing
grease and apply Auto Rex A instead.
b. Do not mix different types of grease.
9) Install back plate to rear housing .
riy. ao
10) Using HUB STAND (28099PA080) and HUB IN-
STALLER "REAR" (927120000), press bearing into hub .
HUB INSTALLER "REAR"
(92712 0000)
X
0
0
j1H U B STA N D
(28009 PA080)
C4-341
Fig . 99
33
BEARING INSTALLER "REAR"
(92710 0000) OIL SEAL INSTALLER "REAR"
(28099 PA070)
HOUSING STAND "REAR"
(28099 PA060)