Table of Contents
Advertisement
ENGINE
[w3A2I 2-3
3 . Camshaft
A: REMOVAL
1 . RELATED PARTS
1) Remove timing belt, camshaft sprockets and related parts
(Refer to Timing Belt [MAO] .)
2) Disconnect cam angle sensor connector .
3) Disconnect ignition coil connectors .
2. CAMSHAFTS LH
~~7
'1
C~`h
c2-227
Fig. 38
1) Remove cam angle sensor with bracket .
2) Remove ignition coils .
Fully loosen ignition coil mounting bolts, and pull the
bolt head using pliers .
Be careful not to pull any harness by mistake .
3) Disconnect blow-by hose and remove cylinder head
cover and gasket .
4) Remove front camshaft cap .
5) Remove camshaft oil seal and plug .
6) Removal of intake and exhaust camshafts .
Since the camshaft thrust clearance is small, the cam-
shaft must be removed by holding it parallel to the
cylinder head . If the camshaft is not parallel to the
cylinder head, the cylinder head thrust bearing portion
may be damaged by the camshaft . To avoid this,
proceed as follows :
31
Advertisement
Table of Contents
Troubleshooting
