Table of Contents
Advertisement
1-4 [010)
PRE-DELIVERY INSPECTION
J: AIR CLEANER
CHECK POINTS
1 . Contamination of air cleaner element
2 . Related parts
Fig. 11
a . The air cleaner element is a viscous type, which
should not be washed or cleaned .
b. If the air cleaner element is broken or damaged,
replace it with a new one.
K: JACK INSTALLATION
CHECK POINTS
Installed condition of jack
L: WINDSHIELD WASHER AND WIND-
SHIELD WIPERS
CHECK POINTS
1 . Installation of windshield washer tank
2 . Checking of fluid level
3 . Direction and quantity of windshield washer
fluid sprayed
4 . Operation of windshield wiper and washer
In areas where water freezes in winter, use SUBARU
windshield washer fluid (003406401) or an equiva-
lent .
The relationship between fluid to water ratio and freez-
ing point is as follows :
Fluid to water ratio (%)
Freezing point °C (°F)
30
- 12(10)
50
- 20 (- 4)
100 (undiluted)
-45(-49)
a. Before raising wiper arm up, set wiper mode switch
under lower cover to "WINTER" .
b . Before checking the windshield wiper, remove the
blade protective cover and clean the windshield glass.
Fig. 12
c. Do not operate the windshield wiper when the
reservoir is empty.
d . Before operating the windshield wipers, be sure to
eject windshield washer fluid onto the windshield .
If the windshield is dry, the wipers' operating speed
and angle of operation will be different from when it is
wet .
e. If the position at which washer fluid is ejected is
wrong : Using an eyeleteer or similar tool, adjust the
direction of the nozzle, be careful not to damage the
nozzle hole.
f. Do not operate the windshield washer continuously
for more than 10 seconds at a time.
M: REAR WINDOW WASHER AND WIPER
CHECK POINTS
1 . Quantity of washer fluid
2 . Direction and quantity of washer fluid sprayed
3. Operation of rear window washer and wiper
6
Advertisement
Table of Contents
Troubleshooting
