Table of Contents
Advertisement
2-11 Iw2BOI
ENGINE AND TRANSMISSION MOUNTING SYSTEM
B : I NSTALLATION
1 . Install engine to transmission.
2 . Tighten bolt which hold right upper side of engine to transmis-
sion .
3 . Remove a lifting device and wire ropes .
4 . Remove a garage jack.
5 . Install pitching stopper onto bracket.
6 . Install torque converter to drive plate.
7 . Connect hoses .
8 . Install canister and bracket .
9 . Install cooling system .
10. Tighten nuts, which hold lower side of engine to transmission,
and install lower side of starter .
11 . Tighten nuts which install front cushion rubber to sub-frame .
12 . Connect power steering hoses to gear box .
13 . Connect ATF cooler hoses .
14 . Install exhaust system.
15 . Install under cover .
1
16 . Connect harness connectors .
17 . Connect accelerator cable .
18 . Connect cruise control cable.
19 . Connect pressure hose onto A/C compressor, and charge with
refrigerant.
20 . Install air intake system .
21 . Connect battery ground cable.
22 . Fill coolant .
23 . Check ATF level, and correct if necessary .
24 . Correct power steering oil, and bleed air .
25 . Move damper, and close front hood .
26 . Take off the vehicle from lift arm .
12
Advertisement
Table of Contents
Troubleshooting
