Basic Position Alignment Method Ii - Mitsubishi Electric C80 Series Connection And Set Up Manual

C80 Series Connection and Setup Manual
14 Setting the Position Detection System

14.1.2 Basic Position Alignment Method II

(1) Preparations
Set the parameters on the
[Abs.Posit.Param.] screen.
(2) Turn the power OFF and ON.
(Only when #2049 has been reset.)
The following are the operations on [Absolute position setting screen].(Select [Mainte] -> [To Abs pos])
(3) Select the axis set to type 4 on the
[Abs.Posit.Param.] screen.
Select the menu [Axis select], enter
the axis name (#1022 axname2
(display axis name)) in the input area
and then press [INPUT].
(4) Select "HANDLE", "HANDL_AXIS", or
"JOG" for the machine operation
switch.
(5) Confirm that the cursor is placed on
"Absolute posn set", input "1" in the
input area and press the [INPUT] key.
(6) Move the cursor to "Zero-P" with
the [ ↑ ] and [ ↓ ] keys.
Enter the value in the input area of
"Zero-P" and press the [INPUT] key.
(* 1)
#2049 type (absolute position detection type) = 4
#2059 zerbas (zero return parameter) =0
The parameters other than #2049 type can also be set in [Absolute
position setting screen].
The input value is registered in the "Absolute posn set" area.
The input value is registered in the "Zero-P" area.
191
(marked point alignment method II)
(position where the axis was stopped)
IB-1501452-C