Setting The Date And Time - Mitsubishi Electric C80 Series Connection And Set Up Manual

C80 Series Connection and Setup Manual
11 CNC CPU Initial Setup

11.4 Setting the Date and Time

Date and time settings on CNC CPU module are automatically sent to the GOT and PLC CPU.
(Note 1) This mode is enabled when "Clock setting" is set for "Time control" on GOT.
Refer to "9.1.4 Setting Time on GOT".
For the "time management" setting, refer to the following manuals:
GOT2000 Series User's Manual (Utility) (SH(NA)-081195)
GT Designer3 (GOT2000) Screen Design Manual (SH(NA)-081220)
(Note 2) When setting the time on CNC CPU, the setting will be reflected to the PLC CPU immediately, but it will be
reflected to the GOT when the power is turned ON again or with the Trigger Type set in the Time setting.
(1) Select [Time] on the Monitr screen.
(2) Select [Time setting] on the integrated time screen.
The time setting mode is entered. The cursor appears at the "#1 Date" position in the Run-out time display.
(3) Set the date and time to "#1 Date" and "#2 Time" respectively.
IB-1501452-C 170