Mitsubishi Electric C80 Series Connection And Set Up Manual page 200

C80 Series Connection and Setup Manual
11 CNC CPU Initial Setup
(c-3) Perform the device setting on CPU3 side of NC3.
Press [Next CPU] at the bottom right. Confirm that [CPU3] is displayed in the top right.
CPU3 (CNC CPU side): Setting example of three units of CNC CPU, 2-part system and 8 control
axes
(c-4) Perform the device setting on CPU4 side of NC3.
Press [Next CPU] at the bottom right. Confirm that [CPU4] is displayed in the top right.
CPU4 (CNC CPU side): Setting example of three units of CNC CPU, 2-part system and 8 control
axes
(6) Turn the power OFF and ON.
169 IB-1501452-C