Mitsubishi Electric C80 Series Connection And Set Up Manual page 93

C80 Series Connection and Setup Manual
5 Installation
(3) Installation surface
Fit the base unit on a flat surface.
If the installation surface is not even, this may strain the printed circuit boards and cause malfunctions.
(4) Installation of the unit in an area where the other devices are installed
Avoid fitting basic unit in proximity to vibration sources such as large electromagnetic contractors and nofuse circuit
breakers; fit the unit on a separate panel or at a distance.
(5) Distances from the other devices
In order to avoid the effects of radiated noise and heat, provide the clearances indicated below between C80 and
the other devices (contactors and relays).
(a)
(a) A device in front of C80: 100mm or more
(b) A device on the right and left of C80: 50mm or more
IB-1501452-C
(b)
62
(b)