Mitsubishi Electric C80 Series Connection And Set Up Manual page 175

C80 Series Connection and Setup Manual
10 PLC CPU Initial Setup
(12) Click [+] in front of the "No. 2 (Receive)" to set the refresh for No.2.
When connecting two units of CNC CPU, set the refresh for CPU No. 3, and when connecting three units of CNC
CPU, set the refresh for CPU No. 4.
[When connecting one unit of CNC CPU]
(Note) The setting for CPU No. 2 above is an example of when the system has one CNC CPU, two part systems and eight control
axes.
[When connecting two units of CNC CPU]
- Refresh setting for CPU No. 2
(Note) The setting value for CPU No. 2 is the setting example for two units of CNC CPU, 2-part system and eight
control axes.
IB-1501452-C
Detail Settings
Points Start
400 X700
626 D1024
64 W80
1184 R4500
64 R6372
50 R8000
400 R11800
200 R0
200 R20000
400 R500
400 R20500
350 R6500
10 R8290
450 R7500
1500 R8300
Detail Settings
Points Start
400 X700
626 D1024
64 W80
1184 ZR4500
64 ZR6372
50 ZR8000
400 ZR11800
200 ZR0
200 ZR20000
400 ZR500
400 ZR20500
350 ZR6500
10 ZR8290
450 ZR7500
1500 ZR8300
144