Making Communication Settings; Setting Ethernet Connection - Mitsubishi Electric C80 Series Connection And Set Up Manual

C80 Series Connection and Setup Manual
9 GOT Initial Setup

9.1.2 Making Communication Settings

Make communication settings on a GT Designer3 project.

9.1.2.1 Setting Ethernet Connection

This section explains the setting procedure for Ethernet connection taking GOT2000 Series GT27 (SVGA) as an
example.
Connect a Ethernet cable to the CNC CPU module and the GOT Ethernet interface.
The following two IP addresses need to be set in order to establish the Ethernet connection.
GOT's IP address (192.168.200.2 in this manual)
CNC CPU module's IP address (192.168.200.1)
GT Designer3
(Note 1) When connecting to a personal computer and a module with USB interface, an electric shock or a module
failure may occur depending on the model of a personal computer or the service condition.
Be sure to refer to "Items related to connection" on "Precautions for Safety" before connecting them.
(Note 2) Unless there is a specific reason, set the CNC CPU default IP address (192.168.200.1).
If any other IP adress is set, the backup data created with GOT backup and restore function cannot be
restored to the replaced CNC CPU module, which has a default IP address.
Setting procedures using the "New Project Wizard" on GT Designer3 are as follows.
SD
or
USB
GT09-C30USB-5P
CNC CPU
R16NCCPU
IP address: 192.168.200.1
115
GOT2000 Series
(SVGA) IP address: 192.168.200.2
100BASE-T
Straight
100BASE-T
Straight
or
IB-1501452-C