Mitsubishi Electric C80 Series Connection And Set Up Manual page 256

C80 Series Connection and Setup Manual
16 Setting the Deceleration Check
(b) Selecting the deceleration check method
There are three methods for the deceleration check, and the method is selected by the parameter.
1) For the execution block with the rapid traverse command (G00/G53)
Parameter
#1193 inpos
0
1
2
2) For the execution block with the cutting feed command (G01/G02/G03)
Parameter
#1306 InpsTyp
(G0/G1 common)
0
(cutting block)
When the parameter "#1306 InpsTyp" is "1", the deceleration check method will be the same as the method of
1) rapid traverse regardless of the value of the parameter "#1389 G1SmthChk".
Deceleration check method
Command deceleration check
In-position check method
Smoothing check method
#1389 #1223
G1SmthChk aux07/BIT1
0
0
1
1 -
225
Determination condition
Deceleration check time
passed
Deceleration check time
passed,
all axis smoothing zero
and all axis in-position
Deceleration check time
passed
and all axis smoothing zero
Deceleration check method
Command deceleration check
In-position check method
Smoothing check method
Determination condition
Deceleration check time
passed
Deceleration check time
passed,
all axis smoothing zero
and all axis in-position
Deceleration check time
passed
and all axis smoothing zero
IB-1501452-C