Windshield Wipers And Washers; Windshield Wiper Operation - Jeep GLADIATOR 2020 Owner's Manual

Hide thumbs Also See for GLADIATOR 2020:
Table of Contents

Advertisement

48
GETTING TO KNOW YOUR VEHICLE

WINDSHIELD WIPERS AND WASHERS

The windshield wiper/washer control lever is
located on the right side of the steering column;
it operates the multiple wiper options. The front
wipers are operated by rotating a switch,
located at the end of the lever.
Windshield Wiper/Washer Lever
W
W
O
INDSHIELD
IPER
PERATION
Rotate the end of the lever upward to the first
detent past the intermittent settings for
low-speed wiper operation. Rotate the end of
the lever upward to the second detent past the
intermittent settings for high-speed wiper
operation.
Front Wiper Control
CAUTION!
In cold weather, always turn off the wiper
switch and allow the wipers to return to the
park position before turning off the engine. If
the wiper switch is left on and the wipers
freeze to the windshield, damage to the wiper
motor may occur when the vehicle is restarted.
Intermittent Wiper System
Use the intermittent wiper when weather
conditions make a single wiping cycle, with a
variable pause between cycles, desirable.
Rotate the end of the lever to the first detent
position for one of four intermittent settings.
The delay cycle can be set anywhere between
1 to 18 seconds.
NOTE:
The wiper delay times depend on vehicle speed.
If the vehicle is moving less than 10 mph
(16 km/h), delay times will be doubled.

Advertisement

Table of Contents
loading

Table of Contents