Mazda CX-9 Grand Touring 2009 Manual page 2048

5. Then, select items from the screen menu in the following order.
Select "PATS Functions".
6. Select "Parameter Reset" from the M-MDS screen menu and perform the procedure according to the M-
MDS screen
7. Perform the security access according to the directions on the M-MDS screen. (See SECURITY
ACCESS PROCEDURE.)
8. Select the replaced parts according to the directions on the M-MDS.
If the PCM is replaced: Select "PCM".
If the keyless control module is replaced: Select "SKE".
NOTE:
9. Select "Ignition Key Code Erase," from the M-MDS screen menu and perform the procedure according to
the M-MDS screen.
CAUTION:
10. Perform the card key programming. (See CARD KEY ID CODE REGISTRATION [ADVANCED
KEYLESS SYSTEM].)
11. Perform the steering lock unit programming. (See STEERING LOCK UNIT ID CODE
REGISTRATION [ADVANCED KEYLESS SYSTEM].)
12. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Exit (From
This Menu)" to finish the M-MDS procedure.
13. After Step 12, wait 5 s or more and then turn the ignition switch to the ON position.
14. Ignition switch to the LOCK position.
15. Disconnect the M-MDS from the DLC-2.
16. Using key 1, turn the ignition switch to the ON position.
17. After verifying that the security light and keyless warning light illuminate for 3 s or more , turn the
ignition switch to the LOCK position and remove key 1.
NOTE:
18. Using key 2, turn the ignition switch to the ON position.
19. Verify that the security light and keyless warning light illuminate for approx. 3 s , and then goes out.
20. After verifying that the security light goes out, turn the ignition switch to the LOCK position using key 2,
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Security and Locks - Mazda CX-9
At this time, do not select the other parts from the M-MDS menu.
The M-MDS displays "You must now program a minimum of two
keys.", however, do not perform the key programming and
proceed to Step 9. If the procedure is not followed, the engine
may not be started. The key programming procedure is
performed at Steps 14 to 19.
Although the security light remains illuminated and DTC 21 is
displayed after approx. 1 min, this does not indicate an improper
procedure. Continue to perform the procedure as indicated.