Mazda CX-9 Grand Touring 2009 Manual page 2365

1. Select the "Toolbox" tab.
2. Select the "Body" tab.
3. Select the "TPMS Functions".
4. Select the "Wheel Unit ID Registration".
2. Leave the vehicle with the engine off for 15 min or more .
3. Verify that the TPMS warning light turns on and off in 0.5 s cycles repeatedly.
4. Drive the vehicle at a speed of 25 km/h {15.5 mph} or more for 10 min to implement the wheel unit ID
registration.
NOTE:
5. Verify that the TPMS warning light turns off.
NOTE:
WITHOUT USING M-MDS
1. Turn the ignition switch to the ON position, then turn it off.
2. Leave the vehicle with the engine off for 15 min or more .
3. Drive the vehicle at a speed of 25 km/h {15.5 mph} or more for 10 min or more .
4. After driving for 10 min, verify that the TPMS warning light does not flash and is not illuminated.
WHEEL UNIT REMOVAL/INSTALLATION
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. When replacing wheel unit (s), register the new wheel unit ID (s). (See WHEEL UNIT ID
REGISTRATION.)
NOTE:
If the wheel unit is replaced with a new one, the ID registration must be
performed. When the ID registration is finished, the data for the new
wheel unit is displayed on the M-MDS.
2008 Mazda CX-9 Grand Touring
2008 SUSPENSION Wheels and Tires - Mazda CX-9
If the ID registration is not completed even after driving the vehicle
for 10 min or more at a speed of 25 km/h {15.5 mph} or more , the
TPMS warning light flashes.
If the wheel unit ID registration cannot be performed after driving 10
min or more, refer to the symptom troubleshooting procedure.