6. Install the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
7. Install the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION .)
8. Connect the negative battery cable.
Fig. 6: Identifying Front Beltline Molding With Clips And Tab
Courtesy of MAZDA MOTORS CORP.
REAR BELTLINE MOLDING REMOVAL/INSTALLATION
REMOVAL
1. Fully lower the rear door glass.
2. Remove the clip A using a protective tape-wrapped flathead screwdriver.
3. Lift (partially peeling back) the rear beltline molding in the direction of the arrow and then remove tabs
B.
4. Remove the clip C.
5. Remove the rear beltline molding.
2008 Mazda CX-9 Grand Touring
2008 ACCESSORIES & BODY, CAB Exterior Trim - Mazda CX-9