Mazda CX-9 Grand Touring 2009 Manual page 2278

FRONT TILT MOTOR INSPECTION
1. Disconnect the front tilt motor connector.
2. Apply battery positive voltage to the front tilt motor terminals and inspect the front tilt motor operation
If not as specified, replace the slide adjuster.
MOTOR OPERATION
Motor operation
Up
Down
3. Connect the front tilt motor connector.
4. Measure the front tilt motor terminal A waveform during motor operation using the oscilloscope.
VOLTAGE SPECIFICATION
Condition Voltage (V)
High output 4.8 or more
Low output 1.0 or less
If not as specified, replace the slide adjuster.
Fig. 15: Front Tilt Motor - Circuit Diagram
Courtesy of MAZDA MOTORS CORP.
REAR TILT MOTOR INSPECTION
1. Disconnect the rear tilt motor connector.
2. Apply battery positive voltage to the rear tilt motor terminals and inspect the rear tilt motor operation
If not as specified, replace the slide adjuster.
MOTOR OPERATION
Motor operation
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Seats - Mazda CX-9
Connection
B+ GND
E D
D E
Connection
B+ GND