Mazda CX-9 Grand Touring 2009 Manual page 1685

17. Steering wheel (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
18. Combination switch (See COMBINATION SWITCH REMOVAL/INSTALLATION .)
19. Center panel (See CENTER PANEL REMOVAL/INSTALLATION .)
20. Meter hood (See METER HOOD REMOVAL/INSTALLATION .)
21. Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
22. Audio unit (See AUDIO UNIT REMOVAL/INSTALLATION .)
23. Steering shaft (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
24. A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION .)
25. Side panel (See SIDE PANEL REMOVAL/INSTALLATION .)
3. Disconnect the front door wiring harness connector (Driver side). (See FRONT DOOR MODULE
REMOVAL/INSTALLATION .)
4. Disconnect the dashboard harness connectors.
5. Remove the brake switch from the brake pedal with the brake switch connector connected. (See BRAKE
PEDAL REMOVAL/INSTALLATION .)
6. Remove the selector lever component. (See SELECTOR LEVER COMPONENT
REMOVAL/INSTALLATION .)
7. Remove the windshield wiper arm and blade. (See WINDSHIELD WIPER ARM AND BLADE
REMOVAL/INSTALLATION .)
8. Remove the cowl grille. (See COWL GRILLE REMOVAL/INSTALLATION .)
9. Remove the windshield wiper motor. (See WINDSHIELD WIPER MOTOR
REMOVAL/INSTALLATION .)
10. Remove the dashboard. (See DASHBOARD REMOVAL/INSTALLATION .)
11. Remove in the order indicated in the table.
12. Install in the reverse order of removal.
Fig. 8: Identifying Front Air Mix Actuator Remove Order - Passenger Side
Courtesy of MAZDA MOTORS CORP.
FRONT AIR MIX ACTUATOR INSPECTION
2008 Mazda CX-9 Grand Touring
2008 HVAC Control System (HVAC) - Mazda CX-9