Mazda CX-9 Grand Touring 2009 Manual page 2113

Fig. 14: Identifying Front Parking Brake Cable And Tab
Courtesy of MAZDA MOTORS CORP.
PARKING BRAKE REMOVAL/INSTALLATION [AWD]
CAUTION:
1. Perform the following procedure and remove the parking brake pedal.
1. Remove the dashboard under cover (LH). (See DASHBOARD UNDER COVER
REMOVAL/INSTALLATION .)
2. Perform the following procedure and remove the front parking brake cable.
1. Remove the front seat (Driver side). (See FRONT SEAT REMOVAL/INSTALLATION .)
2. Remove the decoration panel. (See DECORATION PANEL REMOVAL/INSTALLATION .)
3. Remove the front console box mat. (See FRONT CONSOLE BOX MAT
REMOVAL/INSTALLATION .)
4. Remove the indicator panel. (See INDICATOR PANEL REMOVAL/INSTALLATION .)
5. Remove the front console box. (See FRONT CONSOLE BOX REMOVAL/INSTALLATION .)
6. Remove the dashboard under cover (LH). (See DASHBOARD UNDER COVER
REMOVAL/INSTALLATION .)
7. Remove the side wall. (See SIDE WALL REMOVAL/INSTALLATION .)
8. Remove the console panel. (See CONSOLE PANEL REMOVAL/INSTALLATION .)
9. Remove the console cover. (See CONSOLE COVER REMOVAL/INSTALLATION .)
10. Remove the console. (See CONSOLE REMOVAL/INSTALLATION .)
11. Remove the dust cover.
12. Remove the front side trim (LH). (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
13. Remove the front scuff plate (LH). (See FRONT SCUFF PLATE
REMOVAL/INSTALLATION .)
2008 Mazda CX-9 Grand Touring
2008 BRAKES Parking Brake System - Mazda CX-9
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the
harness if it is pulled by mistake. Before performing the following
procedures, remove the ABS wheel-speed sensor (axle side) and fix it
to an appropriate place where the sensor will not be pulled by
mistake while servicing the vehicle.