Mazda CX-9 Grand Touring 2009 Manual page 1847

2008 BODY & ACCESSORIES Instrumentation/Driver Info - Mazda CX-9
1. Select "Module Programming".
3. Then, select items from the screen menu in the following order.
1. Select "Programmable Parameters".
2. Select "Personality".
4. Select the item name, and than select either "Enabled/Disabled".
Items
BSM buzzer
Fig. 24: Identifying Data Link Connector 2
Courtesy of MAZDA MOTORS CORP.
BLIND SPOT MONITORING (BSM) RADAR TEST
INTRODUCTION
The BSM radar test examines the reflectivity from the SST (reflector) by forcibly emitting radar to the
SST.
One BSM control module is installed on the left and right sides. Perform the radar test for each of them.
Perform the radar test on level ground. The correct test results cannot be obtained if the vehicle and
reflector are set at different heights or different angles.
A radar test cannot be performed correctly if obstructions which interfere with radar emitting adhere to
the BSM control module or the rear bumper. Perform the following procedure before performing the
radar test.
Verify that there is no water or dirt adhering to the radar emitting surface of the BSM control
module and the rear bumper.
Verify that there is no problem with the radar emitting surface of the BSM control module and the
rear bumper such as dirt, application of metallic stickers, or repairs using putty application.
Perform the DTC inspection for the BSM using the M-MDS and verify that no DTCs are displayed.
If any DTCs are displayed, perform troubleshooting according to the corresponding DTC
inspection. (See DTC TABLE [BLIND SPOT MONITORING (BSM)] .)
2008 Mazda CX-9 Grand Touring