Mazda CX-9 Grand Touring 2009 Manual page 1829

2008 BODY & ACCESSORIES Instrumentation/Driver Info - Mazda CX-9
1. Level the vehicle.
2. Complete the "BEFORE SERVICE PRECAUTION". (See BEFORE SERVICE PRECAUTION [MZI-
3.7] .)
3. Disconnect the negative battery cable.
4. Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION [MZI-3.7] .)
5. Remove the fuel line schrader valve cap.
6. Connect a long hose to the disconnected schrader valve cap and drain the fuel into a container used for
collecting gasoline.
Fig. 8: Identifying Fuel Line Schrader Valve Cap & Fuel Distributor
Courtesy of MAZDA MOTORS CORP.
7. Start the fuel pump using the following procedure.
Using M-MDS
1. Connect the negative battery cable.
2. Connect the M-MDS to the DLC-2.
3. Using the simulation function "FP", start the fuel pump.
Without using M-MDS
1. Insert a flathead screwdriver into tab part of the check connector and remove the check connector
cap.
CAUTION:
2008 Mazda CX-9 Grand Touring
Connecting to the wrong check connector terminal may
only to cause malfunction. Carefully connect the specified
terminal.