Mazda CX-9 Grand Touring 2009 Manual page 1682

AIR INTAKE ACTUATOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the dashboard under cover. (Passenger side) (See DASHBOARD UNDER COVER
REMOVAL/INSTALLATION .)
3. Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION .)
4. Insert a flathead screwdriver as shown in the figure and detach the fuse block tab by prying it in the
direction of the arrow.
5. Press the fuse block and remove it from the bracket.
6. Set the fuse block out of the way.
Fig. 3: Detaching Fuse Block Tab
Courtesy of MAZDA MOTORS CORP.
7. Remove in the order indicated in the table.
Fig. 4: Identifying Air Intake Actuator Removal Order
Courtesy of MAZDA MOTORS CORP.
8. Install in the reverse order of removal.
AIR INTAKE ACTUATOR INSPECTION
1. Connect battery positive voltage to air intake actuator terminal G, connect terminal A (or C) to ground,
and then verify that the air intake actuator operates as shown in the table.
2008 Mazda CX-9 Grand Touring
2008 HVAC Control System (HVAC) - Mazda CX-9