Fig. 4: Rotating Adjuster Anchor & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
SECOND-ROW SEAT BELT REMOVAL/INSTALLATION
CAUTION:
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable.
3. Remove the following parts:
1. Trunk box (See TRUNK BOX REMOVAL/INSTALLATION .)
2. Seat side box (See SEAT SIDE BOX REMOVAL/INSTALLATION .)
3. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
4. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
5. Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT
REMOVAL/INSTALLATION.)
6. Rear scuff plate inner (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
7. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
4. Remove the cover.
5. Remove the bolt.
6. Remove the second-row seat belt.
7. Install in the reverse order of removal.
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Seat Belt - Mazda CX-9
The ELR (emergency locking retractor) has a spring that will unwind
if the retractor cover is removed. The spring cannot be rewound by
hand. If this occurs, the ELR will not work properly. Therefore, do not
disassemble the retractor.