Mazda CX-9 Grand Touring 2009 Manual page 2259

Fig. 5: Identifying Second-Row Seat Belt, Bolt & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
SECOND-ROW CENTER SEAT BELT REMOVAL/INSTALLATION
CAUTION:
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable.
3. Remove the following parts:
1. A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION .)
2. Front scuff plate inner (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
3. Rear scuff plate inner (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
4. Front seat belt lower anchor installation bolt (See FRONT SEAT BELT
REMOVAL/INSTALLATION.)
5. B-pillar lower trim (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .)
6. Front seat belt upper anchor installation bolt (See FRONT SEAT BELT
REMOVAL/INSTALLATION.)
7. B-pillar upper trim (See B-PILLAR UPPER TRIM REMOVAL/INSTALLATION .)
8. Trunk box (See TRUNK BOX REMOVAL/INSTALLATION .)
9. Seat side box (See SEAT SIDE BOX REMOVAL/INSTALLATION .)
10. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
11. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
12. Third-row seat belt lower anchor installation bolt (See THIRD-ROW SEAT BELT
2008 Mazda CX-9 Grand Touring
2008 RESTRAINTS Seat Belt - Mazda CX-9
The ELR (emergency locking retractor) has a spring that will unwind
if the retractor cover is removed. The spring cannot be rewound by
hand. If this occurs, the ELR will not work properly. Therefore, do not
disassemble the retractor.