Mazda CX-9 Grand Touring 2009 Manual page 2071

4. Remove the cooling fan component. (See COOLING FAN COMPONENT
REMOVAL/INSTALLATION [MZI-3.7] .)
5. Remove the exhaust manifold insulator (LH). (See EXHAUST SYSTEM
REMOVAL/INSTALLATION [MZI-3.7] .)
6. Remove in the order indicated in the table.
7. Use a clean rag to wipe off the mounting surface on the oil filter adapter and the oil cooler.
8. Install in the reverse order of the removal.
9. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT [MZI-3.7] .)
10. Start the engine and confirm that there is no oil leakage.
If there is oil leakage, repair or replace the applicable part.
11. Inspect the oil level. (See ENGINE OIL LEVEL INSPECTION [MZI-3.7].)
12. Inspect for engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION [MZI-
3.7] .)
Fig. 6: Identifying Water Hose, Oil Cooler, O-Ring & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
OIL COOLER INSTALLATION NOTE
1. Tighten the oil cooler bolts in the order shown in the figure.
2008 Mazda CX-9 Grand Touring
2008 ENGINE Lubrication (MZI-3.7) - Mazda CX-9