Mazda CX-9 Grand Touring 2009 Manual page 1568

FRONT SASH MOLDING INSTALLATION
NOTE:
Double-sided adhesive tape has already been attached to the new front
sash molding.
WARNING:
1. When installing a new front sash molding, follow the procedure below:
1. Remove the adhesive remaining on the body using razor.
2. Remove any grease or dirt from the adhesion surface of the body.
2. When reusing the front sash molding, follow the procedure below:
1. Remove the adhesive remaining on the front sash molding and the body using a razor.
2. Remove any grease or dirt from the adhesion surface of the front sash molding and the body.
3. Apply primer to the bonding area of the front sash molding.
4. Affix double-sided adhesive tape A to the front sash molding as shown in the figure.
2008 Mazda CX-9 Grand Touring
2008 ACCESSORIES & BODY, CAB Exterior Trim - Mazda CX-9
Fig. 32: Peeling Off Rear Sash Film
Courtesy of MAZDA MOTORS CORP.
Using a razor with bare hands can cause injury. Always wear gloves
when using a razor.