Mazda CX-9 Grand Touring 2009 Manual page 2321

6. Pull the front drain hose into the room side.
7. Remove the front drain hose.
Fig. 14: Identifying Front Drain Hose Clips
FRONT DRAIN HOSE INSTALLATION
CAUTION:
1. Apply soapy water to the front drain hose inserting area.
2. Insert one end (the wider end) of the front drain hose into the sunroof frame.
3. Install the front drain hose to the clips, parallel to the pillar and free of slack.
4. Insert the front drain hose joint into the hinge pillar inner hole.
5. Install the following parts:
1. Dashboard (See DASHBOARD REMOVAL/INSTALLATION .)
2. Side panel (See SIDE PANEL REMOVAL/INSTALLATION .)
3. Steering shaft (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
4. Audio unit (See AUDIO UNIT REMOVAL/INSTALLATION .)
5. Instrument cluster (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
6. Meter hood (See METER HOOD REMOVAL/INSTALLATION .)
7. Center panel (See CENTER PANEL REMOVAL/INSTALLATION .)
8. Combination switch (See COMBINATION SWITCH REMOVAL/INSTALLATION .)
9. Steering wheel (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
10. Driver-side air bag module (See DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION .)
11. Column cover (See COLUMN COVER REMOVAL/INSTALLATION .)
12. Hood release lever (See HOOD LATCH AND RELEASE LEVER
2008 Mazda CX-9 Grand Touring
2008 BODY & ACCESSORIES Sunroof - Mazda CX-9
If the front drain hose is pinched or bent anywhere, the water in the
hose may not discharge and enter the inside of the vehicle. During
and after installation of the trims and the headliner, always make sure
there is no interference with the front drain hose. Fix any problem if
found.