Prepare Configuration Test - Siemens Sirius 3RK3 System Manual

Once the connection has been terminated, the program has one of the following statuses:
Status 1:
If a parameter file was already open before the online connection was established, this
parameter file is opened again once the online connection has been terminated, and the
parameters displayed during the online connection are canceled. You can identify this status
by the file name in the title line of the program window.
Status 2:
If a parameter file was not open before the online connection was established, the
parameters currently displayed do not relate to a file. The program behaves as if you had
just created a new parameter set by choosing the menu command "Switching device" >
"New" and then changed individual parameters. You can identify this status by the
designation "Unnamed" in the title line of the program window.
6.4.3.4

Prepare configuration test...

The prerequisite for approving a configuration is a successfully carried out configuration test.
Using the "Target system" > "Prepare configuration test..." menu command, you can create
the printouts that you can use to support the configuration test.
The "Prepare configuration test..." menu command can only be selected if an offline
configuration has been opened.
Create configuration data
1. Call up the "Target system" > "Prepare configuration test..." menu command.
2. In the dialog box which then opens, establish the access path (local device
interface/COM1).
3. Confirm with "OK". A connection to the safety relay is established.
4. Then the following actions are carried out:
● Comparison to see whether the opened configuration agrees with the online configuration
in the MSS. If the comparison reveals differences, it is aborted and an error message is
displayed.
● Consistency check (also of the logic diagram)
If an error is detected, the process is aborted.
● The online configuration is opened.
● Print preview in which you can decide whether the configuration data should be printed
out or saved as a PDF file.
Additional information
You can find additional information on this topic in the
Modular Safety System 3RK3
System Manual, 10/2008, 926 2530-02 DS 02
Description of the software
6.4 Description of the menu commands
Operation
chapter.
113