Siemens Sirius 3RK3 System Manual page 232

Operator control
7.5 Integrating the Modular Safety System 3RK3 in DP master systems
The set PROFIBUS address is applied immediately on the bus side. You do not need to
switch the power OFF and then ON again.
If the set address cannot be transferred to the central unit, the following message is output:
Display
•XXX
NOK••
You can acknowledge this message by choosing "SET" or "MODE". The display then returns
to standard mode.
RST sub-menu
You can use this menu option to restore the device factory settings.
Display
RST•
XXX•
The following entries can appear in the second row:
● "EXIT" (exit)
● "DO" (restore factory settings)
You can use the "MODE" button to switch between the two menu options.
To confirm a selection, choose "SET".
When you choose "EXIT", the process of restoring the factory settings is interrupted and the
display returns to standard mode.
To restore the factory settings, choose "DO".
If you are not permitted to restore the factory settings because the DP interface is currently
exchanging data cyclically with a DP master, the following message is displayed when you
choose "RST":
Display
RST•
LOCK
You can acknowledge this message by choosing "SET" or "MODE". After 30 seconds of
inactivity, the display automatically returns to standard mode.
230
1. row: not flashing
2nd row: flashing
1. row: not flashing
2nd row: flashing
1. row: not flashing
2nd row: flashing
Modular Safety System 3RK3
System Manual, 10/2008, 926 2530-02 DS 02