Manual Start - Siemens Sirius 3RK3 System Manual

6.7.10.2

Manual start

Description
The function "Manual start" requires as start condition status "1" at input IN and input
START. When this condition is fulfilled, the function output Q is activated, i.e. set to "1".
The start signal at the START input is only valid when the following applies:
The time sequence of the START signal corresponds to the values "0 → 1".
Figure 6-20
Parameters
Parameter name
General Name
Element number
Element activated
Function output substitute
value
See also
Messages for start functions (Page 268)
Modular Safety System 3RK3
System Manual, 10/2008, 926 2530-02 DS 02
Manual start
Description/parameter value
You can enter a name for the element here.
Consecutive number which is automatically assigned. You can change
the number.
When this parameter is active, the function is processed in the safety
logic.
When the parameter is deactivated, the set substitute value is made
available at the output Q.
"0" or "1" can be assigned to the substitute value when the element is
deactivated.
Substitute value "0" means output Q = 0
substitute value "1" means output Q = 1
Description of the software
6.7 Functions
203