Dialog "Device Messages" > "Profibus Dp" Tab; Dialog "Device Messages" > "Device Bus Interface" Tab - Siemens Sirius 3RK3 System Manual

Diagnostics / service
8.4 Diagnostics with MSS ES
Memory module
Status
Memory module not plugged in
Memory module defective
Programming successful
Programming error
Memory module too small
Memory module deleted
8.4.1.5 Dialog "Device messages" > "PROFIBUS DP" tab
The "PROFIBUS DP" tab is only available when there is a configured DP interface module.
The configuration supports the following messages:
Status
CPU/Master STOP
DP bus error
DP parameter assignment error
DP configuration error
DP process data exchange
stopped
DP communication ok
8.4.1.6 Dialog "Device messages" > "Device bus interface" tab
The configuration supports the following SC status messages (SC = system interface):
Status
SC bus error
SC parameter assignment error
SC configuration error
SC process data exchange
stopped
Communication O.K.
260
Symbol Meaning
red No memory module is plugged in the safety relay.
red Memory module is defective.
green Programming of the memory module was successful.
red Programming of the memory module was not successful.
red More configuration data were transferred to the safety relay than can be
stored in the memory module.
green The memory module was delected by command beforehand.
Symbol Meaning
CPU STOP: The user program in the PLC is not processed any more.
yellow •
Master STOP: A disturbed communication with the fieldbus master was
•
detected.
red Communication via PROFIBUS DP has been interrupted.
red During parameter assignment in existing communication connection a
parameter assignment error occurred.
red The actual configuration of an existing communication connection does not
match the target configuration. This resulted in an error.
yellow The DP master is no longer receiving any process data.
Possible cause: The controller was stopped with the user program (=CPU
STOP).
green The communication connection to the fieldbus master is set up.
Configuration and parameter assignment of the safety relay have been
executed successfully.
Symbol Meaning
red Communication via the device bus interface is interrupted.
red An error occurred during parameter assignment in existing communication
connection.
red The actual configuration of an existing communication connection does not
match the target configuration. This resulted in an error.
yellow No more process data is exchanged.
green The internal communication link is set up.
Modular Safety System 3RK3
System Manual, 10/2008, 926 2530-02 DS 02