Configuring An Snmp Trap Group - Alcatel-Lucent 7210 SAS E OS System Management Manual

Configuring an SNMP Trap Group

The associated log-id does not have to configured before a snmp-trap-group can be created,
however, the snmp-trap-group must exist before the log-id can be configured to use it.
Use the following CLI syntax to configure an SNMP trap group:
CLI Syntax: config>log
The following displays a basic SNMP trap group configuration example:
A:ALA-12>config>log# info
----------------------------------------------
...
snmp-trap-group 2
...
log-id 2
exit
...
----------------------------------------------
A:ALA-12>config>log#
7210 SAS-E OS System Management Guide
snmp-trap-group log-id
trap-target name [address ip-address] [port port]
[snmpv1|snmpv2c| snmpv3] notify-community communi-
tyName |snmpv3SecurityName [security-level {no-
auth-no-privacy|auth-no-privacy|privacy}] [replay]
trap-target 10.10.10.104:5 "snmpv3" notify-community "coummunitystring"
exit
description "This is a test log file."
filter 1
from main security
to file 1
Event and Accounting Logs
Page 229