Alcatel-Lucent 7210 SAS E OS System Management Manual page 121

source-address
Syntax source-address ip-address
no source-address
Context config>system>security> dot1x>radius-plcy
Description
This command configures the NAS IP address to be sent in the RADIUS packet.
The no form of the command reverts to the default value.
Default By default the System IP address is used in the NAS field.
Parameters
ip-address — The IP prefix for the IP match criterion in dotted decimal notation.
shutdown
Syntax [no] shutdown
Context config>system>security>dot1x
config>system>security>dot1x>radius-plcy
Description
This command administratively disables the 802.1x protocol operation. Shutting down the protocol
does not remove or change the configuration other than the administrative state.
The operational state of the entity is disabled as well as the operational state of any entities contained
within.
The no form of the command administratively enables the protocol which is the default state.
Default
shutdown
timeout
Syntax timeout seconds
no timeout
Context config>system>security> dot1x>radius-plcy
Description This command configures the number of seconds the router waits for a response from a RADIUS
server.
The no form of the command reverts to the default value.
Default
3 seconds
Parameters
seconds — The number of seconds the router waits for a response from a RADIUS server, expressed
7210 SAS-E OS System Management Guide
Values 0.0.0.0 — 255.255.255.255
as a decimal integer.
Values
1 — 90
Security
Page 121