Table 34: Snmp Trap Group Output Fields - Alcatel-Lucent 7210 SAS E OS System Management Manual

Show Commands
...
===============================================================================
A:gal171
A:NS061550532>config>log>snmp-trap-group# show log log-id 1
===============================================================================
Event Log 1
===============================================================================
SNMP Log contents
Cannot send to SNMP target address 10.1.1.1.
Waiting to replay starting from event #2
14 2000/01/05 00:54:09.11 UTC WARNING: MPLS #2007 Base VR 1:
"Instance is in administrative state: inService, operational state: inService"
13 2000/01/05 00:54:09.11 UTC WARNING: MPLS #2008 Base VR 1:
"Interface linkToIxia is in administrative state: inService, operational state:
inService"
....
===============================================================================
A:NS061550532>config>log>snmp-trap-group#
snmp-trap-group
Syntax snmp-trap-group [log-id]
Context show>log
Description This command displays SNMP trap group configuration information.
Parameters
log-id — Displays only SNMP trap group information for the specified trap group log ID.
Output SNMP Trap Group Output — The following table describes SNMP trap group output fields.
Page 300
[size=100
Values 1 — 99

Table 34: SNMP Trap Group Output Fields

Label
Log-ID
Address
Port
Version
Community
Security-Level
next event=3
The log destination ID for an event stream.
The IP address of the trap receiver,
The destination UDP port used for sending traps to the destination,
expressed as a decimal integer.
Specifies the SNMP version format to use for traps sent to the trap
receiver. Valid values are snmpv1, snmpv2c, snmpv3.
The community string required by snmpv1 or snmpv2c trap receivers.
The required authentication and privacy levels required to access the
views on this node.
7210 SAS-E OS System Management Guide
(not wrapped)]
Description