Alcatel-Lucent 7210 SAS E OS System Management Manual page 170

SNMP System Commands
The no form of the command reverts to the default value.
Default
161
Parameters
port-number — The port number used to send SNMP traffic other than traps.
packet-size
Syntax packet-size bytes
no packet-size
Context config>system>snmp
Description This command configures the maximum SNMP packet size generated by this node. If the packet size
exceeds the MTU size of the egress interface the packet will be fragmented.
The no form of this command to revert to default.
Default
1500 bytes
Parameters
bytes — The SNMP packet size in bytes.
snmp
Syntax snmp
Context config>system
Description This command creates the context to configure SNMP parameters.
shutdown
Syntax [no] shutdown
Context config>system>snmp
Description
This command administratively disables SNMP agent operations. System management can then only
be performed using the command line interface (CLI). Shutting down SNMP does not remove or
change configuration parameters other than the administrative state. This command does not prevent
the agent from sending SNMP notifications to any configured SNMP trap destinations. SNMP trap
destinations are configured under the config>log>snmp-trap-group context.
This command is automatically invoked in the event of a reboot when the processing of the
configuration file fails to complete or when an SNMP persistent index file fails while the bof persist
on command is enabled.
Page 170
Values 1 — 65535 (decimal)
Values
484 — 9216
7210 SAS-E OS System Management Guide