Alcatel-Lucent 7210 SAS E OS System Management Manual page 270

SNMP Trap Groups
SNMP Trap Groups
snmp-trap-group
Syntax [no] snmp-trap-group log-id
Context config>log
Description
This command creates the context to configure a group of SNMP trap receivers and their operational
parameters for a given log-id.
A group specifies the types of SNMP traps and specifies the log ID which will receive the group of
SNMP traps. A trap group must be configured in order for SNMP traps to be sent.
To suppress the generation of all alarms and traps see the event-control command. To suppress
alarms and traps that are sent to this log-id, see the filter command. Once alarms and traps are
generated they can be directed to one or more SNMP trap groups. Logger events that can be
forwarded as SNMP traps are always defined on the main event source.
The no form of the command deletes the SNMP trap group.
Default
There are no default SNMP trap groups.
Parameters log-id — The log ID value of a log configured in the log-id context. Alarms and traps cannot be sent
to the trap receivers until a valid log-id exists.
trap-target
Syntax trap-target name [address ip-address] [port port] [snmpv1 | snmpv2c | snmpv3] notify-
community communityName | snmpv3SecurityName [security-level {no-auth-no-privacy
| auth-no-privacy | privacy}] [replay]
no trap-target name
Context config>log>snmp-trap-group
Description This command adds/modifies a trap receiver and configures the operational parameters for the trap
receiver. A trap reports significant events that occur on a network device such as errors or failures.
Before an SNMP trap can be issued to a trap receiver, the log-id, snmp-trap-group and at least one
trap-target must be configured.
The trap-target command is used to add/remove a trap receiver from an snmp-trap-group. The
operational parameters specified in the command include:
Page 270
Values 1 — 99
• The IP address of the trap receiver
• The UDP port used to send the SNMP trap
• SNMP version
7210 SAS-E OS System Management Guide