Alcatel-Lucent 7210 SAS E OS System Management Manual page 263

regexp — Specifies the type of string comparison to use to determine if the log event matches the
severity
Syntax severity {eq | neq | lt | lte | gt | gte} severity-level
no severity
Context config>log>filter>entry>match
Description This command adds an event severity level as a match criterion. Only one severity command can be
entered per event filter entry. The latest severity command overwrites the previous command.
The no form of the command removes the severity match criterion.
Default
no severity — No severity level match criterion is specified.
Parameters
eq | neq | lt | lte | gt | gte — This operator specifies the type of match. Valid operators are listed in the
severity-name — The ITU severity level name. The following table lists severity names and
corresponding numbers per ITU standards M.3100 X.733 & X.21 severity levels.
7210 SAS-E OS System Management Guide
value of router command parameters. When the regexp keyword is specified, the string in the
router command is a regular expression string that will be matched against the subject string in
the log event being filtered.
table below.
Operator
eq equal to
neq not equal to
lt less than
lte less than or equal to
gt greater than
gte greater than or equal to
Severity Number
1 cleared
2 indeterminate (info)
3 critical
4 major
5 minor
6 warning
Values cleared, intermediate, critical, major, minor, warning
Notes
Severity Name
Event and Accounting Logs
Page 263