Consistency Check; Generating System Data After Changing The Configuration Of An Existing System - Siemens SIMATIC TIM 3V-IE DNP3 System Manual

The SINAUT Configuration Tool
6.7 Saving and generating system data
6.7.4

Consistency check

The consistency check is always started automatically before you use the generate/compile
functions in subscriber administration to prevent SDBs or DBs being created with
inconsistent data.
The consistency check can also be started as a separate function using the
consistency...
Errors detected during the consistency check are displayed to the user in an error list.
Image 6-25
If inconsistent connections are found, the error list indicates that cause will be diagnosed in
the connection configuration in the
After eliminating an error, you must save prior to the next consistency check otherwise be
eliminated error will still be reported.
6.7.5

Generating system data after changing the configuration of an existing system

Generating system data after changing the configuration of an existing system
Changes to an existing system made in
system data blocks, on the other hand, can be generated in various configuration tools.
In the following situations, after changes have been made to the project configuration, the
SINAUT configuration tool should be started to generate the system data blocks (SDBs) in
the
● After changing the configuration of a TIM module
● After changing the configuration of a configured connection to a subscriber
● After changing communications parameters of a DNP3 master station
After changing or adding new subscribers or connections, the connection configuration and
then the subscriber administration must be called in the SINAUT configuration tool to
generate the SDBs there.
The activities required following a configuration change are summarized in the section
Changing the configuration (Page 237).
236
menu in subscriber administration.
Example of an error list after running the consistency check
Subscriber Administration
Invalid connections
NetPro
or in
:
System Manual, 12/2015, C79000-G8976-C253-04
dialog.
HW Config
are stored there. The new
SINAUT / Check
TIM DNP3