Module Information - Siemens SIMATIC TIM 3V-IE DNP3 System Manual

Diagnostics and upkeep
7.3 SINAUT diagnostics and service tool
4. Click on the relevant field for the module in the
deactivate archiving of the diagnostic messages.
5. Select the menu or the button of the dialog to change the settings.
6. Close the
or double-clicking on the dialog name in the title bar of the dialog.
Closing the dialog deactivates the
7.3.2.2

Module information

Description of the functions
The
station. The diagnostic data is displayed for the specific module in a series of tabs:
General
●
List of hardware and firmware components with their versions and information on the
status of the CPU module
Diagnostic Buffer
●
List of diagnostic messages
Memory
●
Information on the utilization of the load and work memory.
Time System
●
Information on the data, time, time system and time synchronization as well as on the
operating hours counter of CPU modules
Performance Data
●
Lists of the organization blocks, system blocks and address ranges
Communication
●
Information on transmission speeds, connection resources and cycle load caused by a
communication
Further tabs are displayed for CPU modules:
Cycle Time
●
Set and measured cycle times of CPU modules
Stacks
●
Information on the content of the block stack (B stack), interrupt stack (I stack) and local
data stack (L stack) of CPU modules
Operator activities
1. Select a local subscriber in the
Accessible Nodes
2. Open the dialog by selecting the
3. Select the individual tabs with the mouse.
250
CPU Messages
module information
function reads diagnostic data from the module of the connected
tab
tab
tab
tab
tab
tab
tab
tab
.
W column
dialog by clicking on the
CPU Messages
function.
SINAUT subscriber list
STEP 7 Diagnostics / Module Information
System Manual, 12/2015, C79000-G8976-C253-04
of the module list again to
close dialog
button (x) in the title bar
of the open project or in
menu.
TIM DNP3