Siemens SIMATIC TIM 3V-IE DNP3 System Manual page 38

Uses and properties of the TIM
1.12 Requirements for operation - necessary components and services
Licensing
The software package is a working package that can be used for any number of projects
without licensing.
Components of the SINAUT configuration and diagnostics software
The SINAUT configuration and diagnostics software includes the following components:
● Expanded functions for STEP 7 V5
When you install the SINAUT configuration and diagnostics software, additional software
functions are integrated in the STEP 7 installation:
– Enhancement in STEP 7 NetPro
– Enhancement in STEP 7 HW Config
● The SINAUT Configuration Tool
This is used for project-wide functions such as connection configuration and subscriber
management.
● The SINAUT diagnostics and service tool.
Apart from the diagnostics functions of STEP 7, the diagnostics and service tool can be
used, for example, to load new firmware on a TIM.
Expansions in STEP 7 HW Config
The catalog in STEP 7 HW Config is expanded by the SINAUT folder in the SIMATIC 300
directory. This lists all available TIM modules.
You can select the required TIM module from the SINAUT folder and install it in the S7 rack.
The relevant properties dialogs are available for assigning parameters to the TIM modules,
telecontrol networks and network nodes. They can also be called from NetPro.
Expansions in STEP 7 NetPro
The catalog in STEP 7 NetPro is expanded by the telecontrol networks in the Subnets
directory. You can select the telecontrol networks you require from this directory and install
them in the STEP 7 network window.
The TIM modules are interconnected with the networks in the STEP 7 network window using
the mouse. Errors in the interconnections are rejected immediately.
The relevant properties dialogs are available for assigning parameters to the TIM modules,
telecontrol networks and network nodes. They can also be called from HW Config.
38
With the enhanced functions, WANs and network nodes can be displayed and
assigned parameters in NetPro.
With the enhanced functions, the TIM modules can be displayed and assigned
parameters in HW Config.
System Manual, 12/2015, C79000-G8976-C253-04
TIM DNP3