Operating Mode - Siemens SIMATIC TIM 3V-IE DNP3 System Manual

Industrial remote communication telecontrol
Table of Contents

Advertisement

● Default router: If a default router was specified during configuration, the IP address of the
default router is displayed here.
● IP settings: Indicates where the module obtained the IP parameters from.
Note
With a TIM 4R-IE DNP3, only information on the first Ethernet port P1 is displayed. For an
overview of the status and parameters of both Ethernet ports of the module, refer to
SINAUT Diagnostics,
Network Connection
The
and information on the status and settings of the Ethernet port:
● Link Status: Indicates whether or not a physical connection to Ethernet exists.
● Settings: Shows the setting for detecting network settings, here: "Automatic"
(Autosensing)
● Mode: Indicates the transmission speed and duplexity on Ethernet.
Note
With a TIM 4R-IE DNP3, only information on the first Ethernet port P1 is displayed. For an
overview of the status and parameters of both Ethernet ports of the module, refer to
SINAUT Diagnostics,
Statistics
tab
The
transferred data packets with and without errors since the last reset or restart of the module
is displayed for the send and receive directions. This time time is displayed as module time
in the tab. The statistical values can be reset to zero with the
7.3.2.3

Operating mode

Description of the functions
With the
modules. Apart from the operating mode, the current keyswitch setting and the last operating
mode are displayed for CPU modules.
With TIM and CPU modules, the operating mode can be changed from
Stop
module.
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
IP Parameters
tab
Network Connection
tab for an Ethernet TIM displays the MAC address of the module
IP Parameters
Statistics
tab contains transmission statistics for the Ethernet ports. The number of
Operating mode
function, you can change the operating mode of TIM and CPU
Run
to
. Changing the operating mode from
7.3 SINAUT diagnostics and service tool
tab.
tab.
Reset
Stop
Run
to
triggers a restart on the TIM
Diagnostics and upkeep
button.
Run
Stop
to
or from
253

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Simatic tim 4r-ie dnp3Tim 3v-ie dnp3Tim 4r-ie dnp3

Table of Contents