Figure 4-10 - Version Check On En100 Module Homepage; Figure 4-11 - Version Check In Netview - Siemens EN100 Installation And Activation

2. Check, that the firmware is installed correctly. Open the Internet Explorer insert the IP-address of the
device followed by "/home", e.g. http://172.16.2.1/home. Refresh that page (reload with F5) and check that
the correct firmware is activated. There should be shown the FW version you have uploaded e.g.
Version: 04.10.00.00_V4.
Figure 4-10 - Version check on EN100 module homepage (Note: Shown for version 4.08 here)
Or have a look on the section "Description" within the Netview homepage for the updated devices:

Figure 4-11 - Version check in Netview

SCF 11/2008 V08.10 Page 15 of 29