Siemens SIMATIC TIM 3V-IE DNP3 System Manual page 224

The SINAUT Configuration Tool
6.6 TD7onTIM
If the serial interface is set to the standard RS-485, up to 8 MODBUS slaves can be
connected and monitored (1 slave with RS-232).
Name:
Explanation:
Name:
Memory area: The following options are available:
DB No.:
Address
[byte]:
Name:
Explanation:
Bit status:
ModbusGateway
The "ModbusGateway" system object is used to activate the MODBUS protocol for a serial
interface of the TIM and to configure the connection to the MODBUS slaves.
"Gateway property" box
Name:
Explanation:
224
Gateway number
Internal partner number of TD7onTIM, cannot be set.
Note on the gateway number
In the subscriber management, if a TIM is selected with TD7onTIM with the
system object "ModbusGateway", in the object list in the column "Partner
no." with the Modbus objects, the gateway number is displayed preceded by
"G".
S7 CPU status output byte
• DB: Data block
• Memory bit: Memory bit area
• Output: Process output image (PIQ)
Specifies the DB number in the CPU if the data block memory area (DB) was
selected
Input box for the byte number in the selected memory area
MODBUS slaves
In the 8 input boxes, the MODBUS slaves to be monitored are assigned to
the 8 status bits of the output byte. The MODBUS address is specified for
each MODBUS slave.
Status = 0: Problem on partner or bit not assigned
Status = 1: Partner OK
Connection to TIM interface
Specifying the serial interface of the TIM
Selection for TIM 4R-IE DNP3:
• WAN 1 = interface X1
• WAN 2 = interface X2
System Manual, 12/2015, C79000-G8976-C253-04
TIM DNP3